| |
How
to attach the Timer to your Generation 2 StackMat™ |
|
| |
|
|
| |
These
directions refer to the new Generation 2 StackMat and Timer only.
|
|
|
|
| |
Open
your
StackMat and lay it flat in front of you. Notice the two pre-drilled
holes along the bottom?
Your StackMat
has been pre-drilled to accept the detachable timer. |
 |
 |
|
| |
|
|
| |
Your
Timer "splits" apart.
 |
The
Timer unit is held together by magnetic pads located in each half. |
Hold the
Timer between your hands and gently pull apart at the "seam" (where
the halves meet).
|
 |
 |
|
| |
|
|
| |
| |
 |
Position
the bottom half of the timer underneath the StackMat.
Line
up the protruding "pins" on the timer into the holes on
the StackMat. |
|
 |
 |
|
| |
|
|
| |
|
Position
the top half of the timer on top the StackMat and timer bottom.
Line
up the "pins" and magnetized pads on the Timer and
snap together. |
| |
|
| |
Activate
the Timer by depressing the "Power" button on the faceplate and you
are ready to time your stack. |
|
 |
 |
|
Home
> AU Store > Products
> How to attach the timer to your StackMat
Privacy
Policy
